Microlinks VT300 - user manual Manual de usuario descargar pdf (Pagina 43)

Microscope Application Program http://www.ViTiny.com

response, then go to “setting->video source”. The “auto mode control” must be unchecked. If

want to use “auto mode control” must be checked again as shown in Fig 5-27. If the

auto-exposure function would like to be active, please have this option checked. The drive

doesn‟t support the function, if the selection doesn‟t show on the setting page.

Fig 5-27 auto exposure mode control

5.4 Measurement mode

Measurement mode provides a scale which has built in scale allow you to draw ruler to

measure observation object. Another way is to Freeze frame or loading image then measure. The

measurement toolbar has line, circular, rectangle etc. Also, it can show length, area, radius,

diameter…etc. See Fig.5-28. measurement mode; its toolbar shown as Fig.5-29.

Fig.5-28 Measurement mode

Fig. 5-29 Measurement mode toolbar

Before measuring, make sure to calibrate the scale, please note “scale setting ” the

explanation.

5.4.1Freeze frame “ ”

This function can freeze the previewing image. Once the image freezes, it can use

measurement functions.

5.4.2Load image “ ”

The image which was captured before can be reloaded again. Users can use the

measurement function after reloading the image.

5.4.3Save image “ ”

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 62 63

Sin comentarios

Microlinks VT300 - user manual Manual de usuario Pagina 43